Clicking on a particular MAC address will highlight it and will show the parameter values of the respective device in the Required parameters field. In this window will be displayed the MAC addresses (a.k.a physical addresses) of the devices connected to your network segment. Otherwise the changes will not take place. The parameter changes are applied by clicking on this button.

3x quick button (TCP Setup, TCP data communication, WWW Browser)Ĭlicking on this button will find all the devices on your network segment.NVT enable (for the remote serial port devices).TEA authorisation enable (useful for the security reasons).Define IP filter range (useful for the security reasons).Check and assign main network parameters (IP address, IP mask ans Gateway).

List of all devices on the network segment (MAC list).

Search for the devices over UDP broadcast.

In this window you can assign the IP address to compatible devices ( PortBox, PortStore, PortStore2, I/O Controller, Charon 1 module, Poseidon etc.) Parameters : This tab is to be used with HW-group devices only. The Hercules SETUP is compatible with our free Virtual Serial Port, you can debug applications connected to remote serial port using Windows 2000 or higher.

Test mode (TCP/IP terminal with TEA authorization support and NVT (Network virtual Terminal) parser for remote I/O pins control.

UDP Config utility (IP, Port, MASK, GW setting).

TCP/IP Client terminal (similar to 'Telnet').

Serial port terminal (COM5 and higher support).

Hercules is great utility if you are working with the serial and Ethernet devices & interfaces.

Tcp ip over serial